Gas range & refrigerator repair in Shiprock, NM 87420
Shiprock homes lean hard on propane ranges, water heaters and refrigerators, and the nearest parts are a long way off. We plan each trip around your model number and symptoms so the likely parts are already in the truck.
- Answered 24/7
- San Juan County
- Propane and natural gas
Town we serve
- Area
- Shiprock
- ZIP
- 87420
- County
- San Juan County, NM
- Shop
- 1865 E. Mojave St., Farmington
- Phones
- Answered 24/7
Quick answer for Shiprock
Yes, we repair appliances in Shiprock, about 29 miles west of our Farmington shop where US 64 meets US 491. Most calls here involve propane ranges, water heaters, refrigerators and swamp coolers. Visits are scheduled ahead, and we ask for the model number, the symptoms and a photo first so the right parts ride along. We answer the phone 24/7.
How we plan a repair trip to Shiprock
Shiprock sits where US 64 meets US 491 on the Navajo Nation, with the Shiprock pinnacle standing to the southwest and a Diné College campus in town. From our shop in Farmington it's about 29 miles of highway, which is a long way to drive for one forgotten part. That distance shapes how we work here. We'd rather spend ten minutes on the phone before the visit than show up, find a cracked igniter and drive back for it.
So the first call does most of the sorting. We ask what the appliance is doing, how long it has been doing it, and what changed right before it started. A photo of the model and serial tag, usually inside the fridge door frame, behind the range drawer or on the water heater label, tells us which igniter, valve or board fits. A second photo of the trouble itself, like a weak burner flame or a puddle under a tank, often narrows it further.
Then we book a day and load the parts that match. Finishing on the first visit is the goal, because the guesswork happened before the drive. When a part still has to be ordered, we tell you what it is, why it failed and when we expect to be back. Phones are answered around the clock, and a water heater pouring onto the floor or a dead freezer full of meat gets a tech sent out at any hour.
How propane, wells and wind wear on Shiprock appliances
Many homes around Shiprock cook and heat water with propane rather than piped natural gas. A range or water heater built for natural gas and never converted burns wrong on LP, and the manufacturer's high-altitude instructions matter at this elevation too. The clues are easy to spot: a yellow or lazy flame, soot on the bottom of pans, a burner that lifts off its ports, or an oven that's slow to light. A gas smell means everyone goes outside first; from there, phone 911 or your propane supplier, and call us about the appliance once it's safe.
Water varies from house to house. Some homes draw from a private well, others rely on water that is hauled in, and well water in this part of the state tends to be hard. Minerals collect as scale in water heater tanks, refrigerator water valves and swamp cooler pads, and they shorten the life of each one. Spring wind adds its own wear, packing fine dust into condenser coils and dryer vents. A once-a-year coil cleaning and tank flush go a long way out here.
Repairs Shiprock households call about most
These five problems fill most of our Shiprock calendar.
Propane oven slow to light
A weak hot-surface igniter can take minutes to open the oven gas valve, and you may smell gas before it catches. We test the igniter's amp draw and replace it along with any scorched wiring.
Water heater pilot keeps going out
On older propane heaters a worn thermocouple or a pilot tube clogged with soot is the usual culprit. We clean the pilot assembly, test the thermocouple's output and look over the burner for soot buildup.
Fridge warm, freezer still cold
Usually a frosted evaporator from a failed defrost heater or thermostat, or an evaporator fan that quit. Dust packed into the condenser coils adds strain. We confirm the fault with a meter before ordering anything.
Swamp cooler pads stay dry
A seized pump, a clogged distributor line or a stuck float valve keeps water off the pads, so the cooler just blows warm air. We replace the failed part and scrape out the mineral scale.
Chest freezer humming but warm
A failing start relay or overload leaves the compressor clicking without starting. With a winter's worth of meat inside, that's an emergency, and we treat it as one by sending a tech at any hour.
Repairs we run most in Shiprock
Six services that come up again and again here. The full list is on our appliance repair page.
Getting a Shiprock repair on the calendar
We drive west from Farmington on US 64, through Kirtland and Fruitland, and reach Shiprock where the highway meets US 491. Shiprock visits are grouped on set days when we can, so one trip covers more than one household. Before your day, have the model and serial numbers, a photo of the tag and a short note on what the appliance does. For anything gas, tell us whether it runs on propane or natural gas.
Close to Shiprock
We also work these nearby areas.
Shiprock appliance repair questions
Can a Shiprock appliance repair be finished in one visit?
That is the aim. Because Shiprock is a scheduled trip, we sort out the likely fault on the phone and bring those parts with us. Common igniters, thermocouples, relays, valves and belts usually fit that plan. A control board or a sealed-system problem may need an order and a second visit, and we tell you that up front.
Can you convert my Shiprock range from natural gas to propane?
Yes. Most ranges ship set up for natural gas, and the manufacturer offers an LP kit with new orifices and a regulator change. We install the kit, tune the burner and oven flames for propane and altitude, and leak-test every connection before we leave.
Do you repair appliances in homes on the Navajo Nation around Shiprock?
Yes. We schedule visits to homes in and around Shiprock the same way we do anywhere in our area: a phone call, the model number and symptoms, a set day, and parts matched before we drive. If there is anything we should know about finding the house, tell us when you call.
What should I have ready before a technician comes to Shiprock?
The model and serial numbers, a clear photo of the tag, a photo of the problem if it shows (a leak, a scorched board, a weak flame) and an open path to the appliance. For gas units, know where the shutoff valve is. That little bit of prep often decides whether we finish on the first trip.
Appliance down in Shiprock?
Call any hour with the model number and what it is doing, and we will set the visit.